Family-owned · Mantua, OH · Since 1997(330) 274-0260
Services
Service Areas
Resources
AboutGalleryContact

Ordering, Pallets and Samples

How to Use Your Stone or Brick Sample Board Once You're Home

For homeowners and contractors in Northeast Ohio who have picked up a stone or brick sample board and need to judge it at the actual job site.

Choosing the right sample boards has its own guide, and a board only helps if you look at it the right way. This post covers where to set it, when to look and what to hold it beside before you order.

Wall of stone and brick sample boards in the Mantua showroom

“Super helpful salespeople, plenty of samples to choose from!”

Scott, customer review

Where to Set the Sample Board

For a veneer, wall or fireplace project, stand the board against the surface where the material will go, at the same angle it will have once it is in place. Light strikes a vertical wall differently from a flat patio, so the color of the same piece can read differently in each position.

Choosing the right sample boards comes first, and this post picks up after you have a board in hand. You can take a sample board home from the Mantua yard, so the decision gets made at the job site instead of under yard lighting.

When to Check the Board

When the board is on site, look at it in morning light, at midday and in the late afternoon, and once more on an overcast day. Daylight changes both color and shadow, and a piece that looks warm at noon can read cooler in shade.

For a surface that will face the street or a patio door, check the board at the hours when people will actually be looking at it.

What to Hold the Board Beside

For color decisions, hold the board next to the finishes that will stay in place around it. Stone, brick and mortar colors are judged against their neighbors rather than in isolation.

  • Roof shingles and fascia
  • Window frames, doors and trim
  • Siding, existing brick or existing stone
  • Gutters, downspouts and garage doors
  • The driveway, walkway or patio surface nearby

How Far Back to Stand

At the distance where the finished surface will normally be seen, from the street or from the patio, the board reads as one overall color rather than as individual pieces. Step back until the edges of single stones or bricks stop standing out, then judge the overall tone.

In close-up, the board shows texture, edge detail and the pattern of joints. Look at both distances before deciding.

Natural Variation and Printed Color

Natural stone and brick can vary from piece to piece, so a board shows a range of color rather than one fixed shade. Look across the whole board instead of only at the single piece you like most.

Printed or on-screen color can also differ from the real product, and a Belgard cut sheet for its Mega-Arbel paver says colors may vary from those shown and recommends viewing actual product samples.

Photos and Notes at Home

For a record you can compare later, photograph the board in place at each time of day and write down the hour and the weather. Phone cameras can adjust color automatically, so use the photos to compare one look with another and not as a color match.

Bringing Your Findings Back to the Yard

When matching a brick project to existing old masonry, bring a sample or photos to the Mantua yard and ask about matching old brick. The yard offers brick matching. Bring a close-up photo of the brick and a second photo from about twenty feet back. A sample brick helps if you can bring one, and a few help if the brick is a blend. Kelly Supply can also send a salesperson to the site to look.

For a stone project, start with the natural stone and manufactured stone boards at the yard. Natural stone sample boards and manufactured stone sample boards each have their own page. Questions about board sizes, which products have boards and the check-out terms should go to the yard counter. Sample boards are free to borrow: take them home and bring them back when you are done.

Frequently Asked Questions

Why does a stone or brick look different at home than at the yard?

At home, daylight, the colors around the material and the viewing angle all change how a board reads, so judge it where it will be installed instead of only in the yard.

How many times of day should I check a sample board?

Check it in morning light, at midday and in the late afternoon, plus once on an overcast day, because daylight changes color and shadow through the day.

Can I use photos to match brick?

Photos can help a conversation at the yard, though phone cameras can shift color. Bring a physical sample of the existing brick when you can, along with the photos.

Choose, Match and Order from One Yard

Call NowRequest a Quote