Wood-Burning Fireplace Inserts at the Mantua Yard
Wood-burning fireplace inserts are part of the fireplace inserts range at Kelly Supply Co. in Mantua. The yard sells inserts and does not install them, and a quote is required for pricing, so request a quote with the model you are considering. Call the yard for the current models and their specifications.
Fit starts with the fireplace opening, so bring its width, height and depth to the yard counter when you ask about a model.

Why Choose a Wood-Burning Insert
A wood-burning insert can heat a room more efficiently than an open fireplace because it closes in the fire. EPA-certified stoves can be up to 50% more energy efficient, and an open wood fireplace creates 20 times the air pollution of an EPA-certified wood heater, in EPA's Burn Wise guidance on efficiency.
Compare the spec sheets for the inserts on your list, because a brochure efficiency figure is that model's result under test. Call the yard for the current models and their specifications.
EPA-Certified Wood Inserts
EPA-certified wood inserts carry an EPA-certified label, and the cleanest wood-burning appliances are marked that way, in EPA's guide to choosing wood-burning appliances. The same guide notes that most stoves in homes are not EPA-certified, so the label is worth checking on any insert, new or used.
EPA-certified inserts can use a catalytic or a non-catalytic combustion design, and both designs are built to reburn smoke before it leaves the flue. The manufacturer's spec sheet names which one a model uses. Call the yard for the current models and their specifications.

Sizing a Wood-Burning Insert
Sizing a wood-burning insert starts with the space to heat, because the choice should weigh efficiency, emissions and the size of the room, in EPA's guide to choosing wood-burning appliances. An insert that is too large for the room can overheat it, and one that is too small leaves it cold.
The manufacturer's spec sheet gives each model's heating-area and heat-output ratings, and the yard counter can read those with you against a floor plan.
Fuel matters as much as size, because properly dried wood should read 20% or less on a moisture meter, and split wood should season for at least 6 months for softwood and 12 months for hardwood, in EPA's Burn Wise guidance on efficiency.
Will an Insert Fit Your Existing Fireplace
A wood-burning insert is designed to retrofit into the firebox of an existing masonry or metal fireplace, and a factory-built fireplace needs an insert that was designed and tested for that unit, in EPA's guide to choosing wood-burning appliances. Fit depends on the opening and the flue, so measure both before choosing a model.
A certified installer should check the flue liner in a masonry chimney, in the same EPA guide, and the installer can also say whether the liner should be insulated. Kelly Supply Co. sells the insert and the parts around it, including fireplace and chimney accessories, and the installer you hire sets the liner and venting.

