Wood and gas inserts in Mantua, OH
Fireplace Inserts Supplier in Northeast Ohio
For homeowners in Northeast Ohio with an open masonry fireplace who want to compare wood and gas inserts and need to know what size, venting and clearances apply before they order.
Kelly Supply Co. sells fireplace inserts from its Mantua yard, with the stone, brick and chimney accessories for the surround and delivery across Northeast Ohio.
Call (330) 274-0260 during yard hours (Mon-Fri 7:00am-4:00pm) to reach the Mantua yard counter.

“Our contractor gave us info on Kelly Supply in Mantua, OH, to see if we could find something we liked for remodeling our wall behind our wood burner. The selection was incredible. The staff was knowledgeable & patient. They even made suggestions, but weren’t rude about it.”
BTU Output & Square-Footage Coverage by Insert Type
BTU output and square-footage coverage for an insert come from the manufacturer's label, because each model publishes its own rated heat output and heated area. Efficiency, emissions and the size of the space should all be weighed before choosing a wood-burning appliance, according to the EPA's Burn Wise guidance, which points to a BTU estimator based on the room's dimensions. Call the yard for the current models and their specifications.
Before you compare models, measure the width, height and depth of your firebox opening. A masonry firebox must be at least 20 inches deep, as specified by the Residential Code of Ohio in Section 1001.6, and an insert has to fit that opening with the clearances its listing requires. An insert retrofits an open masonry fireplace, and a flue in poor condition may need to be relined before the insert goes in. The smoke chamber walls above the firebox must total at least 8 inches of solid masonry, or 6 inches including a firebrick or vitrified clay lining, as specified by the same code in Section 1001.8.
| Insert type | What the label gives | What to compare |
|---|---|---|
| Wood-burning | Rated heat output and the EPA emission rate | Output against the room, and the EPA certification label |
| Gas | Rated heat output and efficiency | Output against the room, and the venting the manufacturer specifies |
Wood-Burning Fireplace Inserts
Wood-burning fireplace inserts are sold at Kelly Supply Co. as Quote required items. The emission limit for new wood stoves dropped to 2.0 grams of smoke per hour from May 15, 2020, for catalytic and noncatalytic models tested with crib wood, according to the EPA.
A limit of 2.5 grams per hour applies to stoves tested with cordwood under an approved method, and older uncertified stoves release 15 to 30 grams per hour, according to the same EPA page. Ask for the EPA label and the certified emission rate on any wood insert. Call the yard for the current models and their specifications.
Liners used with solid fuel-burning appliances need to be insulated, as published by the Chimney Safety Institute of America, and a masonry fireplace should be swept at 1/8 inch of sooty buildup, sooner if glaze is present, according to the same institute.


Gas Fireplace Inserts
Gas fireplace inserts are also Quote required, and a gas insert still depends on a sound chimney, because masonry chimneys must be lined under Section 1003.11 of the Residential Code of Ohio. Venting for a gas insert follows the model's listing and the manufacturer's installation manual rather than a single rule for all models.
An unvented gas log heater must not be installed in a factory-built fireplace, as specified by the Residential Code of Ohio in Section 1004.4, and factory-built fireplaces must be listed and installed to the conditions of that listing under Section 1004.1. Annual inspections apply to gas chimneys too, according to the Chimney Safety Institute of America.
Fireplace & Chimney Accessories
Fireplace and chimney accessories are sold per item, call for pricing, and the accessories page covers winterizing as well.
Chimneys must extend at least 3 feet above the highest point where they pass through the roof and at least 2 feet higher than any part of a building within 10 feet, as specified by the Residential Code of Ohio in Section 1003.9. A chimney needs at least 2 inches of air space to combustibles, as specified by the same code in Section 1003.18. Flashing where the chimney meets the roof is one more item to look at during the yearly inspection.
Chimneys, fireplaces and vents should be inspected at least once a year for soundness, according to NFPA 211 as quoted by the Chimney Safety Institute of America. A sweep who knows the NFPA 211 Level 1 inspection can check the flue before the season.
Fireplaces covered by the same chapter must have an exterior air supply, and the combustion air passageway must be at least 6 square inches and no more than 55 square inches, as specified by the code in Section 1006.


Fireplace Inserts, Supplier Information and Masonry in One Place
This page covers fireplace inserts, the fireplace supplier information and the masonry for the surround in one place. A common myth says an insert needs no chimney, yet an insert still vents through a lined chimney.
Kelly Supply Co. sells inserts and does not install them, so installation should follow the manufacturer's instructions and the product listing, with the local building department consulted on permits. Call the yard for the current models and their specifications.
Why Buy Fireplace Inserts From Kelly Supply Co.
Kelly Supply Co. brings 29 years supplying Northeast Ohio to fireplace inserts, with natural stone, manufactured stone and thin brick for the surround sold from the same yard.
Hearth extensions of a masonry fireplace must be at least 2 inches thick, as specified by the Residential Code of Ohio in Section 1001.9.2. They must reach at least 16 inches in front of the opening and at least 8 inches beyond each side, as specified by that code in Section 1001.10. An opening of 6 square feet or larger raises those reaches to 20 inches in front and 12 inches at each side, as specified by the same section.
A mantel within 12 inches of the opening can project no more than 1/8 inch for each 1 inch of distance from it, as specified by the code in Section 1001.11.

More in Fireplace Inserts
Fireplace & Chimney Accessories
Fireplace and chimney accessories from the Mantua yard, priced per item, with winterizing guidance for Northeast Ohio homeowners. Call for pricing.
Wood-Burning Fireplace Inserts
Wood burning fireplace inserts from the Mantua yard, by quote. See EPA-certified labels, sizing and fit for your fireplace opening in Northeast Ohio.
Gas Fireplace Inserts
Gas fireplace inserts from the Mantua yard, by quote. See how fuel, venting, ignition and sizing fit a Northeast Ohio fireplace opening.
Frequently Asked Questions
What size fireplace insert do I need?
Insert size starts with your firebox measurements and the heat output the manufacturer rates for the model, matched to the room. Call the yard for the current models and their specifications.
Are your fireplace inserts EPA certified?
EPA certification applies to new wood-burning appliances, and the label on a given insert shows its certified emission rate. Call the yard for the current models and their specifications.
Do gas fireplace inserts need to be vented?
Gas fireplace inserts need venting that matches the model's listing and the manufacturer's installation manual, and masonry chimneys must be lined under the Residential Code of Ohio.
Do you install fireplace inserts?
Kelly Supply Co. sells fireplace inserts and does not install them, so installation should follow the manufacturer's instructions and your local building department's rules.
How often should a chimney be inspected?
A chimney should be inspected at least once a year, according to NFPA 211 as quoted by the Chimney Safety Institute of America.
Do you also sell chimney accessories?
Fireplace and chimney accessories are sold per item, call for pricing.
Choose, Match and Order from One Yard
Send the request form and the Mantua yard team follows up quickly during yard hours (Mon-Fri 7:00am-4:00pm).
